Greetings!
I have two suggestions for some convenience features for Har-Bal.
The first one involves the Match Loudness feature. Frequently when I need to use reference files they are, of course, often louder due to compression/limiting. This will often incur "overs" in the source if I attempt to raise the source file to the reference file. What I usually do (and I also pass this on as a tip to Har-Bal users) is I use the key command 'Ctrl M', make note of the increase, return it to zero (Ctrl Home), switch to the reference file, and decrease it by the same amount, and raise the control room monitors accordingly, sparing me from creating a file with too many zero points. My suggestion (finally!) is to create a Key Command (perhaps Ctrl + Shift M) that would bring the reference file down the level of the source file.
My second suggestion is somewhat similar and that would be a Key Command to directly raise or lower levels without having to use the mouse first on the fader to invoke the page up/ page down function. Something like 'Ctrl 1' to raise the level by 1 dB, 'Ctrl 2' by 2 dB, etc.and again 'Ctrl + Shift 1' to lower it by 1 dB.
Just some ideas I hope others might find useful too.
So Long!
Two ideas for key commands
-
- Posts: 24
- Joined: Wed Jun 08, 2005 10:48 pm
- Location: misters.masters@sympatico.ca
-
- Posts: 24
- Joined: Wed Jun 08, 2005 10:48 pm
- Location: misters.masters@sympatico.ca
No problem. I'll take your suggested key combos on board.
By the way, I believe I may have an ideal automated spectrum adjustment algorithm (ie. one button press solution) that is largely fool proof and should work at least 95% of the time. It is based on a simply study of what I generally do when adjusting spectrums without a reference and is an algorithm that does not use a reference. It should also largely preserve all the feature bumps in the spectrum as well.
I've yet to code it up but I feel confident that It should work without problem. If it does then I'll probably have an interim release of another version of HarBal prior to the Mac port release as this feature is something should be put out ASAP if at all possible. If I have success with this I'll most likely add your suggestions to the release.
Regards,
Paavo.
By the way, I believe I may have an ideal automated spectrum adjustment algorithm (ie. one button press solution) that is largely fool proof and should work at least 95% of the time. It is based on a simply study of what I generally do when adjusting spectrums without a reference and is an algorithm that does not use a reference. It should also largely preserve all the feature bumps in the spectrum as well.
I've yet to code it up but I feel confident that It should work without problem. If it does then I'll probably have an interim release of another version of HarBal prior to the Mac port release as this feature is something should be put out ASAP if at all possible. If I have success with this I'll most likely add your suggestions to the release.
Regards,
Paavo.
-
- Posts: 24
- Joined: Wed Jun 08, 2005 10:48 pm
- Location: misters.masters@sympatico.ca
Ditto!FunDog wrote:I believe I may have an ideal automated spectrum adjustment algorithm (ie. one button press solution) that is largely fool proof and should work at least 95% of the time. It is based on a simply study of what I generally do when adjusting spectrums
Can't wait to try this!
FunDog
-Susan