if i already have a wavefile at -0.1db, and i don't want it to limit but i see the limiter moving, how do i turn it off
2nd question. where do i adjust the options for 16 or 24 bit export res.
how to turn off the limiter
limiter response
i find if my original file is -.01db, and i change it to -6db at the limiter, my result is too low . If for example i only have 1or2 bars in the limiter area, does that cause any significant harm to my wavefile?
My personal view is that it is unlikely to make any audible difference but you asked for no limiting and that is the "only" way to to it short of clipping the track which will be noticeable. If a track is that hot and you want to EQ it you have to re-limit it (or clip it) to maintain the volume.
The idea is that after processing to -6dB you bring it up again by 6dB using the limiter of your choice. I thought that is what you were asking. If you don't want to re-limit it the only other option is using "normalisation" (ie. bringing the level up by an amount that is just short of clipping on the highest peak). The choice is yours.
Paavo.
The idea is that after processing to -6dB you bring it up again by 6dB using the limiter of your choice. I thought that is what you were asking. If you don't want to re-limit it the only other option is using "normalisation" (ie. bringing the level up by an amount that is just short of clipping on the highest peak). The choice is yours.
Paavo.
limiter fine with couple bars
limiter fine with couple bars
I've been through this many times and am getting a little tired of it all.
The limiter is protecting the signal from clipping. If you have a limiter bypass switch all you'll end up doing is "CLIPPING" your track. If you want clipping fine, we can add a button called clipping, but if the purpose to all of this was to make sure you get "NO CLIPPING" the ONLY way to ensure this is to turn down the gain which turns off the limiter so why have an extra button that serves little purpose.
The limiter has an outceiling of -0.1dB and is hard knee so if your track level goes no higher than -0.1dB post EQ then the limiter will not do "ANY" limiting! If you post process a limited track with EQ it will need further limiting to bring it up to the same level as pre-EQ (assuming no clipping) so you have to limit it somewhere. Either Har-Bal or your favourite limiter but it will still need limiting, hence the suggestion of -6dB gain setting to guarantee the Har-Bal limiter is not doing anything and then making up the difference externally.
Cheers,
Paavo.
The limiter is protecting the signal from clipping. If you have a limiter bypass switch all you'll end up doing is "CLIPPING" your track. If you want clipping fine, we can add a button called clipping, but if the purpose to all of this was to make sure you get "NO CLIPPING" the ONLY way to ensure this is to turn down the gain which turns off the limiter so why have an extra button that serves little purpose.
The limiter has an outceiling of -0.1dB and is hard knee so if your track level goes no higher than -0.1dB post EQ then the limiter will not do "ANY" limiting! If you post process a limited track with EQ it will need further limiting to bring it up to the same level as pre-EQ (assuming no clipping) so you have to limit it somewhere. Either Har-Bal or your favourite limiter but it will still need limiting, hence the suggestion of -6dB gain setting to guarantee the Har-Bal limiter is not doing anything and then making up the difference externally.
Cheers,
Paavo.