Har-Bal Users Forum BBS

Hi Earle & Paavo,
i'm doing a quick test on a mix right now and I'm having trouble with the filter file function.

I load my reference into harbal...
I save it as an eq filter file, i then load my mix, and open the ref filter file.
then...nothing happens, it says at the top right hand corner the filter name but there are no changes to the eq of my mix.

A little puzzled, please help!!!

Hi Ged,

A reference is just a reference and no more than that. If all you've been doing is loading a reference and then saving the filter, the filter you save will just be all pass flat frequency response (unless you've made edits to the filter). No changes to the mix occur by loading a reference. The changes are up to you.

regards,


Paavo.

HarBal wrote:Hi Ged,

A reference is just a reference and no more than that. If all you've been doing is loading a reference and then saving the filter, the filter you save will just be all pass flat frequency response (unless you've made edits to the filter). No changes to the mix occur by loading a reference. The changes are up to you.

regards,


Paavo.

yeh, oops just figured it out after posting that above, my mistake.
Paavo, did you rework the eq algo's? they sound alot smoother than 1.5?

Essentially no. The only difference in EQ between 1.5 and 2.0 is the filter now has extra headroom to allow you to push it into limiting. I suspect that people think it sounds smoother because intuitQ is helping them design between filters. To be honest, I've noticed the same thing but I know I didn't actually change any filter code and I know I've been using intuitQ.

How about thrying this: take the smooth souding track your working on and save the filter to a version 1.5 compatible filter file, then load it up in 1.51 and see how it sounds. Provided your not using air and provided your not pushing it into clipping it should sound the same (theoretically).

Cheers,


Paavo.