REFRENCE

Having problems using the greatest Visual Mastering software of the century? Use this area of the Forum to post your technical questions to Earle and Paavo regarding Har-Bal or ask questions regarding how to work on a certain area of the software? Post away!
Post Reply
nogimmikz
Posts: 7
Joined: Fri Jun 02, 2006 10:09 pm

REFRENCE

Post by nogimmikz »

do any of you guys know what i would need the refrencce level knob on the back of a psp Vintage VU meter?
Top
HarBal
Site Admin
Posts: 761
Joined: Mon Apr 19, 2004 8:18 pm
Contact:
Contact HarBal

Post by HarBal »

No doubt it adjusts the sensitivity of the meter and represents the level that 0VU correpsonds to. IT would be for calibration purposes. Get a 0VU reference signal and put it into the meter and adjust the knob so that it reads 0VU.

To tell you the truth I'm not sure what level 0VU corresponds to. I have vague recollections of it being the same as 0dBm into a 600 ohm load though I'm not certain about that. If it is then that would correspond to 775mVolts RMS.

Cheers,


Paavo.
Top
Post Reply

Return to “Questions and Answers”